Features: | Fast Charging Technology ,Half Charging Time | Network: | 4G/3G Sim Card + WiFi |
---|---|---|---|
IR Distance: | 10m | Sensor: | CMOS |
Video Compression: | H.265+/H.265/H.264+/H.264/MJPEG | Night Vision: | Super Star Light Level |
Usage: | Security Surveillance | Day/Night: | Auto Switch IR Cut |
Waterproof Rate: | IP67 | View Angle: | 140 |
Special Features: | Dual WIFI Mode | Resolution: | 1600P/30P1440P/30P 1296P/30P 1080P/30P 720P/30P |
High Light: | CMOS Police Body Worn Camera,IP67 Police Body Worn Camera,3500mAh Law Enforcement Body Camera |
H2.65 WIFI Police Body Worn Camera For Police Evidence-Capturing
M502 is a police body worn camera with wifi dual wifi mode that enables to charge fastly.In addition, its dustproof and waterproof standard reaches IP67.
Product Paramenters
Night vision
|
Star light night vision |
waterproof Rate | IP 67 |
Video Format | H.265 AVI/MPEG4 |
Audio Format | AAC/MP3 |
Videos Resolution | 1600P/30P1440P/30P 1296P/30P 1080P/30P 720P/30P |
Picture Pixel | 32M/21M/16M/12M/10M/8M/5M/3M/VGA |
Burst Shot | Off /2/3/5/10/15/20 |
GPS | Yes, on/off |
Wi-Fi | Yes, AP or STA mode |
Important event Mark | Support |
LCD Screen | Top small screen 0.96 inch | ||||||||||||||||||||
Video Section | 5 min /10 min /15 min | ||||||||||||||||||||
Pre-record | support | ||||||||||||||||||||
Post-record Time | Support | ||||||||||||||||||||
Battery Type | Built-in 3500mAh lithium battery | ||||||||||||||||||||
Charging | Less than 3 hours | ||||||||||||||||||||
Recording Time | Over 12 hours continuous recording at 720P | ||||||||||||||||||||
Password Protect |
Password protection to prevent unauthorized changes on menu or access to camera's memory. |
||||||||||||||||||||
Standard Accessories | Charger | Type C Cable | Charging Base | 360° Rotatable Metal Clip |
||||||||||||||||||||
Dimension
|
L57x W27x H 80
|
Key Features
H.265 CODES
Same video quality ,half storage size
Dual WIFI Mode(AP+STA)
Wifi AP to remote control by phones
WIfi STA for live streaming ,GPS live tracking
two way intercom
Top Screen shows important information
Top small display indicate information like battery life ,Memory card status and more
Front big button recording
Front big button recording /panic button recording
IP64 Grade
IP67 waterproof
2 meters dropresistance
New type C connecter ,fast charging
The new fast charging technology ,half charging time
Super star light level Night vision
With the star light level image sensor , to Keep the color of the recording ,More bright and clear image at night ,
Top Small screen design
The top small display screen shows an officer at -a-glance information without being a distraction. It shows battery life ,recording status and SD card memory and more information.
Dual Wifi Mode
Wifi AP to remote control by phones
WIfi STA Mode can connect the hot pot of the phones for live streaming ,GPS live tracking,two way intercom.
FAQ:
Q1. Do you offer free sample?
Yes, we offer free samples. But you would pay sample fee firstly and sample fee will be returned when massive order is placed.
Q2. How does you ensure the quality of products
All goods are 100% inspected before shipping, we do at least 5 test, including In-coming raw material test, sample test then bulk produce, functional test, burn-in test, appearance inspection.
Q3. Lead Time
1. Sample order can be delivered from our factory in 3 working days.
2. General order can be delivered from our factory in 3-5 working days.
3. Big order can be delivered from our factory in 15-35 working days at most.
Q4. Technical Support
We have strong R&D team to support our customers, and if you have any question for the technology of our products, please email to us, reply will be sent to you immediately;
Also if you have any doubt for the information on our website or any feedback for the quality of our products, please email to us, and thanks for your all comments in advance.
Any questions,please inquire us,thank you!
Q:WIFI can’t connect?
A:Whether the device supports WIFI function
Whether the WIFI SSID number and password are set correctly
Wi-Fi password only allows WEP encryption mode
WIFI cannot be set in the same network segment as the local IP
WIFI must write an IP address (same network segment as the route)
Q: The SD card indicator is off or flashing?
A: The SD card indicator has 3 states: off, on and flashing; the meanings are as follows:
Off: The SD card is not inserted or the device cannot recognize the SD card;
On: The SD card exists, but it is not the disk currently being recorded;
Blinking: This SD card exists and is currently recording disk;
If both SD card indicators are on and not flashing, the possible causes are as follows:
According to the user's setting in the menu, the device thinks that there is no recording task currently;
Both SD cards have been recorded full, but the automatic overwrite in the menu is turned off;
Both SD cards are full. Although the automatic overlay in the menu is turned on, since the recording files in the two SD cards are all alarm recording files, they cannot be deleted and cannot start a new recording;
Q:The power of the camera is connected, but there is no image on the monitor?
A:Check whether the power supply is connected to the 12V position. The power output of the device has two voltages: 5V and 12V.
Q: Do individual GPS and AGPS need to be used with SIM card?
A: GPS does not require a network, it needs to be outdoors to receive satellite signals, AGPS is network positioning, you need to turn on wifi or 4G function to locate successfully, you can locate indoors
Q: No GPS signal?
A: The possible reasons for GPS no signal are as follows:
No GPS antenna is connected;
The GPS antenna is placed indoors;
GPS module is damaged;
Q: When recording on SD card and hard disk, what is the way of recording overwrite?
A: The SD card and the hard disk record separately. When the SD card and hard disk are full, the original recordings in the respective disks will be deleted.
Q: Can remote switch operation be performed??
A: Not currently supported, but it can be done.
Q: Can the SD card be used first? Can SDHC cards be supported?
A: We currently mainly use SanDisk SD cards,yes.
Q: Does the infrared of BWC need to be turned on manually or automatically?
A: In the setting menu, you can select the mode of the infrared function, there are closed and open, the default is to open automatically according to the surrounding environment light intensity (note: the open state of the Android machine is the long open state, and the ambient light is automatically detected)
Q: Can Recoda's BWC connect to a third-party non-Recoda CMS backend system? Or is it possible to access the BWC of a third-party platform?
A: Need to contact our company to evaluate the difficulty of docking
Q: Is it possible to change the memory size of the BWC device?
A: According to the BWC model, if you do not see the memory card slot, it means that the model does not support replacing the memory card
Q: What is the effect of the pre-recording function and the post-recording function?
A: If the pre-recording function is turned on and the pre-recording time is 30s, the video will start to be recorded after the power is turned on. After the time is more than 30 seconds, it will continue to record and continuously cover the video 30 seconds ago. When the video button is pressed, it will be pressed The first 30 seconds are also recorded in the recorded video. The delay recording function is to continue recording for 30 seconds after pressing the stop recording button
Q: How long can a 32G BWC record video?
A: It needs to be calculated according to the environment's light, video definition, code stream and video compression format
Q: Does BWC segment video need to be operated every once in a while?
A: No, the segmented video will automatically save the video separately by time length, without human intervention.
Q: How to change the display language of the device to the language of your own country?
A: Open the setting menu interface language setting function can be modified, if you do not find the corresponding language, you need to contact the manufacturer to customize the language package to use.